Installation
INSTALLATION IS SIMPLE, STREAMLINED AND UNCOMPLICATED
Installation is simple, streamlined and uncomplicated. The sales pack consists of two precision SABS approved side marker lamps plus installation instructions; it is powered by an additional cable connected to the existing trailer or vehicle lights. There are two models available. One for general road conditions and one for boat trailers.
1. Installation
It consists of 2 easy-to-install precision spot lights (see above) which are fitted on both sides of the rear ends of your vehicle according to traffic regulations pertaining to side-marker lamps. These two spot lights provide you with a bright 300 mm round light spot exactly at the point where your vehicle ends. These lights are connected to the vehicle's rear lights.
2. Possible positioning on Trailer/Truck Bumper
(Please mount according to applicable road safety regulations)
1. For trailer-bumper mounting from both rear corners.
2. Drill 4 holes using template supplied.
3. Place cable in the middle hole and tightening the screws with seal rings supplied and connect to the existing cable.
4. Adjust the light with a supplied 4mm allan key to suit your preferred positioning of the light-spots, and then tighten the screw.
3. Electrical diagram
TargetLight is a DIY product and can easily be connected to the existing rear lights and stays on the trailer.
4. Specifications
Size: 41mm x 82mm x 38mm
Lightsource: 12V/5W OSRAM Mini-halogen 6411 (standard and replaceable)
Frame: durable plastic to high-tech international standards.